Ever heard of cleaning your teeth using a gel with LED Light technology? Are you fed up of the permanent yellow marks on your teeth line? Is your teeth bone turning pale that makes you uncomfortable? Does your smile feel less attractive? Then this is the right product for you.
By cleaning the teeth for only 10 minutes per day, this technology proves wonders for the consumers. The Lux Teeth Whitening System combines professional whitening gel with LED light technology to remove stains in just 10 minutes per day. It has a soft and comfortable mouth tray that whitens your top and bottom teeth at the same time in one treatment.
Your smile becomes bigger and better. Confidence level increases with an improved smile. The glow is reflected on your face. Highly recommended by the customers and the consumers
Simple 5 Steps allows you to get the full benefit from the Lux Teeth Whitening LED Gel
STEP 2: Boil a pan of water approximately 4’’ in depth so the tray will be fully immersed while keeping the tab above the water. After the water has come to a boil, turn the heat. Down so it stops boiling and place the tray in the hot water for 5 seconds. The trays will become very pliable at this point and will tend to stick together. While the tray is in this state avoid twirling them as it may damage the natural contour of the tray.
STEP 3: Lift the tray vertically from the water using the tab.
Carefully and quickly place the tray around your teeth and
Gently bite down to mold the tray to your teeth.
STEP 4: Once you are satisfied with the fit, trim the front
Tab away from the tray with scissors. Make sure it is level
With the front surface of the tray.
STEP 5: Brush and floss your teeth before continuing. Place a small line of gel (clear gel in the syringe) in the front portion of the tray for it to cover your front 6-8 teeth. The gel might irritate the gums if the trays are overloaded. Insert the trays very carefully keeping the gel on the teeth
And away from the gums.
STEP 6: Insert light and wear the trays for 15 minutes. If sensitivity or irritation occurs, wait 24 hours between treatments. Be sure to rinse trays thoroughly after use.
Repeat the process daily. Frequency should be 24 hours.
Perform the cleansing until desired white shades are achieved.